CLST-1/4 type has fan-cooling device, the standards assemble with 1/4 HP motor and TOP-10A rotary oil pump, the flow rate could be 1.2 to 1.4 L/min. The type of motor and oil pump also can be chosen on request. Please look the specification for details.
This is circulating lubricator, which means the oil flows out, then comes back into the oil tank through the cyclic inlet, thus could save the usage volume of oil. The cyclic inlet has magnetic filter, which can block the impurities and assure the oil clean.
After installing and connecting the oil pipe, feed oil till oil flows out, then start to use this lubricator.
It used a high quality pump that not only has steady output pressure and low noise, but also can assure each lubrication point with output of oil. It can be applied for large machines' request.
It has a pressure-regulating valve, which can adjust the pressure and easy to check from the pressure gauge.
It has a float switch that can detect the volume of oil. It will have abnormal signal when the oil level is lower than the standard.
The standards assemble with TOP-10A rotary oil pump, also can be changed to TOP-11A, TOP-12A, and TOP-13A according to the difference of discharge volume. Please look the specification for details.
The max pressure of CLST-1/4 type is 5 kgf/㎝2, and after cooling, the temperature of oil will be room temperature plus 10℃.
There are many kinds of oil container to be chosen: 20L, 30L, 40L, 60L, 100L, and 150L.
It can be added a fan on request, which will have better cooling effect.
As ordering, please detail the voltage, pole, HP, and hertz of motor.
Malaysia
