Description
Product Description:
• WD-40 Specialist® Fast Drying Contact Cleaner
• This product cleans sensitive electronics and electrical equipment.
• It also works on larger electric motors, armatures, relays, electric panels and generators.
• Ideal for use on: printed circuit boards, controls, switches, tape heads and precision instruments
• Safe to use on all plastics, rubber and metal
• Excellent for cleaning oil, dirt, flux residue and condensation from sensitive electronics and electrical equipment
• It rapidly penetrates into hard to reach areas and dries quickly, without leaving any residue.
• Fast acting, non-conductive cleaner
• Dielectric strength up to 35,000 Volts per 0.1 inch
• ROHS Compliance
Direction of use:
• Shut off all power and allow any hot surfaces to cool.
• Shake the can well and apply by spraying directly on surface to be lubricated and protected.
• Hold the can 6 to 8 inches away from the surface
• Spray directly on to the electrical device or circuit board
• To eliminate and remove any contaminants that may cause loss of electric contact.
• Tilt surface while cleaning and allow any excess cleaner to run off.
• Allow product to dry completely and through
• Vent the system before restoring power.
More detail about ZUSEN HARDWARE TRADING SDN BHD
Malaysia
