High-Temperature Bottom Loading Furnaces with Molybdenum Disilicide Heating Elements and Fiber Insulation up to 1650 /掳C

The motorized lifting table significantly simplifies the charging of the high-temperature furnaces LHT .. LB Speed. The heating all around the cylindrical furnace chamber provides for an opitimal temperature uniformity. 
 

• Tmax 1650 °C
• High-quality heating elements made of molybdenum disilicide offer very good protection against chemical interaction between charge and heating elements
• Dual shell housing made of textured stainless steel sheets with additional fan cooling for low surface temperature
• Exclusive use of insulation materials without categorization according to EC Regulation No 1272/2008 (CLP). This explicitly means that alumino silicate wool, also known as “refractory ceramic fiber” (RCF), which is classified and possibly carcinogenic, is not used.
• Excellent temperature uniformity thanks to three (LHT 02/17 LB Speed) or four-sided (LHT 01/17 LB Speed) heating of the furnace chamber
• Furnace chamber with a volume of 1 or 2 liters, table with large floor space
• Precise, motorized toothed belt drive of the table with button operation
• Opening time of table approx. 30 sec., completely open
• Exhaust air vent in the roof
• Type S thermocouple
• Defined application within the constraints of the operating instructions
• NTLog Basic for Nabertherm controller: recording of process data with USB-flash drive
• Controller P570 (50 programs with each 40 segments)

• Over-temperature limiter with adjustable cutout temperature as temperature limiter to protect the furnace and load
• Stackable saggars for loading in up to two or three levels, depending on model
• Reduced opening time of table to 10 sec., completely open
• Adjustable air inlet through the floor
• Process control and documentation via VCD software package