LPV-100E: Pilihan Terbaik di Selangor, Malaysia, Kuala Lumpur (KL), Shah Alam Winston Resources

Deskripsi

Features:
‧Constant voltage design
‧Universal AC input / Full range
‧Fully encapsulated with IP67 level(Note.8)
‧Withstand 300VAC surge input for 5 seconds
‧Protections: Short circuit / Overload / Over voltage
‧Fully isolated plastic case
‧Cooling by free air convection
‧100% full load burn-in test
‧Low cost, high reliability
‧Suitable for LED lighting and moving sign applications(Note.7)
‧3 years warranty

Model		LPV-100E-5	LPV-100E-12	LPV-100E-15			LPV-100E-24
Output	DC voltage	5V	12V	15V			24V
	Rated current	12A	8.5A	6.7A			4.2A
	Current range	0~12A	0~8.5A	0~6.7A			0~4.2A
	Rated power	60W	102W	100.5W			100.8W
	Ripple&noise (max.)	80mVp-p	120mVp-p	120mVp-p			150MVp-p
	Voltage tolerance	±8.0%	±5.0%
	Line regulation	±1.0%
	Load regulation	±6.0%	±2.0%
	Setup,rise time	2000ms, 25ms / 230VAC 2000ms, 25ms / 115VAC
	Hold up time	50ms/230VAC 14ms/115VAC at full load
Input	Voltage range	90 ~ 264VAC 127 ~ 370VDC
	Frequency range	47 ~ 63Hz
	Efficiency	80%	85%			87%	88%
	AC current	2.2A/115VAC 1.2A/230VAC
	Inrush current	COLD START 75A(twidth=700μs measured at 50% Ipeak) at 230VAC
	Leakage current	0.25mA/240VAC
Protection	Overload	110 ~ 150% rated output power
		Protection type：hiccup mode，auto-recovery after fault condition is removed
	Over voltage	5.75~ 6.75V	13.8~ 16.2V		17.5~ 20.25V		27.6~32.4V
		Protection type : Shut off o/p voltage, clamping by zener diode
Environment	WORKING TEMP.	-25 ~ +70℃ (Refer to "Derating Curve")
	Working humidity	20%~90%RH non-condensing
	Storage temp,humidity	-40℃~+80℃,10%~95%RH
	Temp. coefficient	±0.03%/℃ (0 ~ 50℃)
	Vibration	10~500HZ,2G 10min/1cycle,period for 60min, each along X, Y, Z axes
Safety&EMC	Safety standard	IP67 approved; Design refer to TUV EN60950-1
	Withstand voltage	I/P-O/P:3KVAC
	Isolation resistance	I/P-O/P:>100M Ohms / 500VDC / 25℃/ 70% RH
	EMC emission	Compliance to EN55022 (CISPR22) Class B, EN61000-3-2 Class A(≤80% load), EN61000-3-3
	EMC immunity	Compliance to EN61000-4-2,3,4,5,6,8,11; EN55024, light industry level, criteria A
Others	MTBF	703Khrs min. MIL-HDBK-217F (25℃)
	Dimension	1905237mm (LWH)
	Packing	0.63Kg;20pcs/13.6Kg/0.55CUFT

NOTE:
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 ℃ of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. Derating may be needed under low input voltage. Please check the static characteristics for more details.
5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by thecomplete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
6. Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time.
7. Suitable for indoor use or outdoor use without direct sunlight exposure. Please avoid immerse in the water over 30 minute.
8. The unit might not be suitable for lighting applications in EU countries. Please check with your local authorities for the possible use of the unit.

Lihat detail lebih lanjut tentang Winston Resources