Cedar Digital Torque Driver DID Series provide a wide range of torque measurement with a very high accuracy by MSP Metrology (M) Sdn Bhd from Cedar Japan.
Feature
- The torque screwdriver is Ergonomic and light weight, yet ruggedly constructed
- Available in: lb-in, kg-cm and N-m (mN-m)
- Peak, Real Time and Peak Down measuring mode (selectable)
- 800 data memory
- Programmable High and Low set points with both audible beep and Green/Red LED indicator for uniform torque tightening or GO/NO GO testing
- Programmable screw tightening counter
- Programmable Auto Zero function resets unit to zero for easy operation
- Both CW and CCW operation
- ASCII format output (USB)
- Runs on internal NI-MH batteries (for 12 hours) Auto shut-off after 10 min, of non-use
- AC charger and carrying case included
Yes-No Decision Conditions, Etc.. Can Save Five Channels
- A channel is only changed even if bolting conditions change.
- It is not necessary to reset up a maximum value and a minimum value one by one like former.
Full Specifications
| Specification | DID-05 | DID-4 | |
| Measuring Range |
2.0 ~ 500 mN-m 0.020 ~ 5 kgf-cm 0.020 ~ 4.5 lbf-in |
0.020 ~ 4 N-m 0.20 ~ 40 kgf-cm 0.20 ~ 35 lbf-in |
|
| Accuracy | ±0.5% (499 or less digit ±3 digit) | ||
| Display | The 4 figures digital display of LCD | ||
| The measurement direction | CW-CCW (right and left) | ||
| Measuring mode |
P-P Peak | Peak load value hold | |
| T-R Track | Indication of real time torque value. | ||
| P-D Peak down | Holding Load Value at the moment to change from upward to downward | ||
| C Real-time output | Load torque value is outputted every about 1/160 second | ||
| Decision function |
Setting of torque value | Programmable High and Low setpoints with both audible beep and Green/Red LED indicator for uniform torque tightening or GO/NO GO testing | |
| The Maximum, the minimum, and the average value | The data number, the maximum, the minimum value, and the average value of memory data are displayed. | ||
| Automatic Clearance | Automatically clear the displayed value after certain time (0.5 – 3.0 sec, selectable at each 0.5 sec). Setting 0.0 sec for manual Zero clearance | ||
| A setup of the number of counts | One to 99 count (count in a direction with a bundle) | ||
| Data spec | Data transfer |
ASCII format (Baud rate: 19200) When outputting data,the cable(USB mini B) is needed. |
|
| Data memory | 800 data | ||
| Power supply | Ni-MH chargeable battery 1.2V × 4 cells 800mAh | ||
| Auto power save | 10 minutes no use, automatically switch off. | ||
| Charging time | From empty – less than 5 hours | ||
| Continuous working time | 12 hours | ||
| Bit/Socket part | φ4 | HEX6.35 | |
| Weight | About 180g | About 400g | |
| Attachment |
Bit (＋) #1 For one-way ×1 For fixation×1 |
Bit (+) #1 #2 | |
| Bit holder | |||
| One way Bit holder | |||
| Accessories (one piece each) |
AC/DC adaptor | ||
| An inspection report, a proofreading certificate, a traceability system figure | |||
Malaysia
