Precision Bench Centers (Standard/ Vertical/ Special Type)

1) PRECISION BENCH CENTRES (STANDARD TYPE)

• Used for eccentricity and deflection Measurement of shafts, etc.

• Used for eccentricity and deflection Measurement of shafts, etc.
• Parallellism between table upper surface and center is assured.
• Center entry/exit is performed by one touch lever.

・According to your requirement, we can manufacture variations with carbide center or brolly center.
・Dial gauge and test bar are not included.

• Small sized type of standard model tester.

• Small sized type of standard model tester.
• Used for eccentricity and deflection Measurement of shafts, etc.
• Parallellism between table upper surface and center is assured.
• Center entry/exit is performed by one touch lever.

・According to your requirement, we can manufacture variations with carbide center or brolly center.
・Dial gauge and test bar are not included.

• Tester with V Block (V Width 16mm) attached to stock.

• Tester with V Block (V Width 16mm) attached to stock.
• Can be used for measurement of shafts, etc with center hole, or without hole
• On the dial gauge stand, a lever type dial gauge is installed.
• Center entry/exit can be performed by a one touch lever.

※・Dial gauge and test bar are not included.

•   Surface Plate flatness is JIS Grade 1.

• Surface Plate flatness is JIS Grade 1.
• Surface Plate is bag type, therefore long term accuracy can be manitained.
• The Stock moves up/down by gear.
• Due to balance weight within the column, it moves with minimum force.

※・According to your requirement, we can manufacture head spin type.
  ・Test bar is not included.