Nominal diameter | 3/8 ″ (10A) | |
Material connection | Inlet | Rc3 / 8 |
Discharge port | ||
Air connection | Supply port | Rc1 / 4 (with air cock) |
exhaust port | Rc3 / 8 (with muffler) | |
Service air pressure | 0.2 to 0.7 MPa | |
Discharge pressure | 0.7MPa | |
Discharge rate / cycle | 50mL | |
Slurry limit (maximum passing particle diameter) | 1mm or less | |
Mass |
DP-10BA □: 3.5kg DP-10BS □: 5.2kg DP-10BP □: 3.0kg |
DP-10BA □ series uses nylon (PA) as the material for the valve receiver. Pay attention to corrosion resistance. Not suitable for MEK etc. |
Body (wetted part) material |
Diaphragm material |
||
C: Chloroprene (CR) |
N: Nitril Gum (NBR) |
T: Fluorocarbon resin |
|
A: Al alloy (ADC12) |
DP-10BAC (851743) |
DP-10BAN |
DP-10BAT |
S: Stainless (SCS14) |
DP-10BSC (851746) |
DP-10BSN |
DP-10BST |
P: Polypropylene (PPG) |
DP-10BPC |
DP-10BPN |
DP-10BPT |
Body (wetted part) material |
Diaphragm material |
||
H: Polyester type thermoplastic elastomer (TPEE) |
S: Polyolefin-based thermoplastic elastomer |
* H / T |
|
A: Al alloy (ADC12) |
DP-10BAH (851750) |
DP-10BAS (852674) |
DP-10BAH / T |
S: Stainless (SCS14) |
DP-10BSH |
DP-10BSS |
DP-10BSH / T |
P: Polypropylene (PPG) |
DP-10BPH |
DP-10BPS |
DP-10BPH / T |
* H / T is Diaphragm: Polyester thermoplastic elastomer (TPEE), Ball: Fluororesin (PTFE).
Note) Clicking the model / product number will display the parts list and parts exploded view.
Note) Download by right-clicking ''Save Target As'' ''''
Model |
DP-10BA |
DP-10BS |
DP-10BP □ |
|
Ball valve |
DP-10B □□ ・ ・ ・ Same as diaphragm material |
|||
Valve seat |
A5056 |
SUS316 |
DP-10BPN ... NBR DP-10BPC ... CR |
|
Valve holder |
PA |
PPG |
||
Center disc |
A5056 |
PPG (SUS304 *) |
★SUS304insert material ★ Initial self-lifting height is 1m for all models.
The maximum operating pressure of the body wetted part resin type (BP □) depends on the liquid temperature. Be sure to check the “Liquid temperature and maximum working pressure diagram”. |
Lihat detail lebih lanjut tentang Merns (M) Sdn Bhd