Product Description
WARRIOR brand of construction and waterproofing products are the most famous and reputable ones in Singapore.
It can also be poured/ injected into cracks to stop water seepages.
It is so highly concentrated that it can be diluted twice with water!
WARRIOR W-1 CEMENT STRENGTHEN is a one-component acrylic-based liquid resin mixed with normal Portland cement
mortar or white cement which is used as a flexible
adhesive, patching mortar, base coat, etc.
Uses
WARRIOR W-1 CEMENT STRENGTHEN can only be applied to sound,
clean, dry, well-prepared, and frost-free surfaces. After
mixing with cement, it may be used:
● As a base coat for floor screeds
● As a flexible adhesive for tiling and glazing
● As a flexible patching mortar
● As a concrete repair mortar
● As an abrasion-resistant lining
Advantages
■ Easy to use.
■ Excellent adhesion and durability.
■ Crack resistance.
■ Good flexural strength.
■ Good impact strength.
■ Freeze-thaw resistance.
■ Vapor permeable.
■ Low alkalinity.
■ Excellent water resistance.
Instruction of Use
Surface Preparation
Substrates: All substrate surfaces must be clean, free from grease, oil, laitance, dirt, and contaminants that might affect adhesion. It is recommended to give the substrate a rough or light-broom finish for better bonding strength.
Insulation board: Insulation board must be well protected, clean, dry, and free from all bond-inhibiting
materials and rasped if necessary before installation.
Mixing
WARRIOR W-1 CEMENT STRENGTHEN should be mixed thoroughly with normal Portland cement or white cement by using a low-speed electrical or pneumatic power stirrer.
Mixing time is a minimum of 3-4 minutes until a homogeneous mix is achieved.
Mixing Ratio:
WARRIOR W-1 CEMENT STRENGTHEN: 1
Cement: 1
Adjust mix if necessary by adding a small amount of
clean water to achieve the desired texture finishing.
Avoid re-tempering after mixing the product
Malaysia
