It is tested and verified by TUV Rheinland in Taiwan and had passed CE of Machinery Safety Directive (MSD 89/392/EEC) and Low Voltage Directive (LVD 73/23/EEC). It conforms to UN's requirement of "Necessary Safety, Hygienic Regulation.
It is without timer (also could be controlled by Programmable Logic Controller) and has to work with volume distributors. With CAB or CBB type distributor, oil will feed during operation time. With CDB or T type distributor, oil will feed during interval time.
The discharge volume is fixed. The lubrication points of volume distributor supply a fixed flow of oil.
It has shaded-pole type motor with a temperature controller. When the temperature reaches 100 degrees, the motor will shut down 5 minutes to protect the motor..
It has a spark-eliminator inside to prevent the sparks producing when the electric current is running. The spark-eliminator can avoid PLC (Programmable Logic Controller) to be interfered.
It has a float switch that can detect the volume of oil. It will have abnormal signal automatically when the oil level is lower than the standard.
It has a pressure switch device and been set up as 8kgf/cm2, which assures the oil volume of lubrication point and check if the oil pipe works normally. The standard specification is NC (Normal Close) contact, which means if the pressure is abnormal, it will have signal. NO (Normal Open) contact is on request.
It has a pressure gauge for checking if the pressure is normal.
It has a feed-oil button, press the button and oil will feed immediately.
Its function is similar to CEN04 type. The difference is CEN03 type is without timer and CEN04 type is controlled by a timer. CEN01 and CEN02 types are resistance type of lubricators.
Malaysia
