| Outline | EMX5016CF | |
|---|---|---|
| Mixing capability | Mixing channels | 8 Mono + 4 Stereo +2 Return |
| AUX | 4 (incl. 2x Effect Send) | |
| MAIN | Stereo | |
| Input channel functions | CH1-8: HPF, Compressor, 3-band mid-sweep PEQ Insert I/O; CH9-16: HPF, 3 band PEQ | |
| On-board processors | 2x SPX, 2x Digital 9-band GEQ, Feedback suppressor, Frequency response correction, Maximizer, YSProcessing | |
| I/O | Mic inputs | 12 |
| Phantom power | +48V DC; ON/OFF | |
| Line inputs | 4x Stereo | |
| Control and others | 2x Foot switch, Lamp | |
| On-board amplifiers | Maximum output power @4ohms | 500W/ch |
| Maximum output power @8ohms | 370W/ch (100V model), 350W/ch (120V model), 320W/ch (220-240V model) | |
| Output selection | 500W, 200W, 75W; L/R, AUX1/MONO, AUX1/AUX2 | |
| General specifications | EMX5016CF | |
| Total harmonic distortion | Less than 0.3% | |
| Frequency response | 0, +0, -3dB 20Hz-20kHz | |
| Hum & noise level | Equivalent input noise | -128dBu |
| Residual output noise | -68dBu (Speaker out); -95dBu (Line out) | |
| Crosstalk | -68dB | |
| Protection circuit | Load protection | Power switch on/off mute, DC-fault (power supply shutdown/manual reset), Clip limiter (≧THD 1%; compression) |
| Amplifier protection | Thermal (heatsink temp ≧90 degrees celsius; output mute/auto reset), Vl limiter (RL ≦2ohms) | |
| Power supply protection | Thermal (heatsink temp ≧100 degrees celcius; power supply shutdown/manual reset) | |
| Cooling | 2x Variable-speed fan | |
| Power requirements | Depend on area of purchase; AC100V, 120V or 220-240V; 50/60Hz | |
| Power consumption | 500W | |
| Dimensions | W | 444mm; 17-1/2in |
| H | 155mm; 6-1/8in | |
| D | 493mm; 19-7/16 (12U) | |
| Net weight | 11kg; 24.3lbs | |
| Accessories | Owner’s Manual, AC power cord | |
| Input terminal | PAD | GAIN | Actual load impedance | For use with nominal | Input level | Connector | ||
|---|---|---|---|---|---|---|---|---|
| Sensitivity | Nominal | Max. before clip | ||||||
| CH INPUT A 1-8 | 0dB | -60dB | 3kohms | 50-600 ohm Mics | -80dBu | -60dBu | -40dBu | XLR-3-31 type *3 |
| -16dB | -36dBu | -16dBu | +4dBu | |||||
| 26dB | -34dB | -54dBu | -34dBu | -14dBu | ||||
| +10dB | -10dBu | +10dBu | +30dBu | |||||
| CH INPUT B 1-8 | 0dB | -60dB | 10kohms | 600ohm Lines | -80dBu | -60dBu | -40dBu | TRS phone jack |
| -16dB | -36dBu | -16dBu | +4dBu | |||||
| 26dB | -34dB | -54dBu | -34dBu | -14dBu | ||||
| +10dB | -10dBu | +10dBu | +30dBu | |||||
|
ST CH MIC INPUT 9/10-15/16 |
-60dB | 3kohms | 50-600 ohm Mics | -80dBu | -60dBu | -40dBu | XLR-3-31 type | |
| -16dB | -36dBu | -16dBu | -10dBu | |||||
|
ST CH LINE INPUT 9/10-15/16 |
-34dB | 10kohms | 600ohm Lines | -54dBu | -34dBu | -14dBu |
Phone jack, RCA pin jack |
|
| +10dB | -10dBu | +10dBu | +30dBu | |||||
| CH INSERT IN (1-8) | - | 10kohms | 600ohm Lines | -20dBu | 0dBu | +20dBu | Phone jack | |
* 0dBu= 0.775Vrms
| Output terminal | Actual source impedance | For use with nominal | Output level | Connector | |
|---|---|---|---|---|---|
| Nominal | Max. before clip | ||||
| ST OUT [L,R] | 150ohms | 600ohm Lines | +4dBu | +20dBu | TRS phone jack |
| ST SUB OUT [L,R] | 150ohms | 600ohm Lines | +4dBu | +20dBu | TRS phone jack |
| AUX SEND 1,2 | 150ohms | 600ohm Lines | +4dBu | +20dBu | TRS phone jack |
| EFFECT SEND 1,2 | 150ohms | 600ohm Lines | +4dBu | +20dBu | TRS phone jack |
| CH INSERT OUT 1-8 | 600ohms | 10kohm Lines | 0dBu | +20dBu | TRS phone jack |
| REC OUT [L,R] | 600ohms | 10kohm Lines | -10dBV | +10dBV | RCA pin jack |
| PHONES [L,R] | 100ohms | 40ohm Lines | 3mW | 75mW | ST phone jack |
| SPEAKERS | 0.1ohms | 4ohm Speakers | 125W | 500W |
speakON Phone jack |
* 0dBu=0.775Vrms. 0dBV =1.0Vrms
Malaysia
