The XP-CPRO2L lift access controller can be used to control the access to the levels in the building. It uses the Mio-R16 to control the access to each of the floor. Each card holder is assigned with a floor zone setting which contains the information of how he/she can access to each of the level.
You may configure that the card holder only able to access to a certain levels but denied entry into others.
The XP-CPRO2L lift access control system can be used together with other MicroEngine’s door access equipments under the management of a single software system – xPortal2007 or xPortalNet. In this way, the accessibility of the card holder into each of the area including the control inside the lift can be managed from a single point.
|
Features |
Functions |
|---|---|
| Autonomy | Distributed data and processing |
| Downlink | 2 wire RS485 |
| No of CDP | 2 |
| No of floor | 64/COP |
| Battery backed real time clock | Yes |
| Onboard rechargable battery | Yes |
| Card Number | 6 Digits |
| Continuous reads when door left open | Yes |
| Operating modes | Card only |
| Time Zone | 255 |
| Time Set | 255 each with 3 intervals |
| Holidays | 30 |
| Onboard Watchdog Circuit | Yes |
| Auto lock release by time zone | Yes |
| Cardholders | 10,000 |
| Events | 20,000 |
| RAM memory | At least 128 KByte |
| RAM protected by on board battery | Yes |
| Firmware EPROM / flash memory | At least 128 KByte |
| Addressing via switch | Yes |
| Onboard buzzer | Yes |
| Communication ports | RS485 |
| Polarity protection for power connector | 4 digits |
| Power | 12VDC |
| Relay interface unit | MTR16 |
| Reader interface unit | MK800 |
Malaysia
