KTM-WN117A1P Contrast Sensors SICK | Sensorik Automation SB

KTM-WN117A1P | Part no.: 1061787

• Communication interface: IO-Link
• Adjustment: Cable, IO-Link, Teach-in button
• Teach-in mode: 2-point teach-in static/dynamic + proximity to mark
• Light source: LED, RGB
• Sensing distance: 12.5 mm
• Switching output: NPN
• Light spot size: 1.5 mm x 6.5 mm
• Connection type Detail: Male connector M8, 4-pin

• Features

  Dimensions (W x H x D)	12 mm x 31.5 mm x 21 mm
  Sensing distance	12.5 mm
  Sensing distance tolerance	± 3 mm
  Housing design (light emission)	Rectangular
  Light source	LED, RGB 1)
  Wave length	470 nm, 525 nm, 625 nm
  Light emission	Long side of housing
  Light spot size	1.5 mm x 6.5 mm
  Light spot direction	Vertical 2)
  Receiving filters	None
  Adjustment	Cable, IO-Link Teach-in button
  Teach-in mode	2-point teach-in static/dynamic + proximity to mark

  • 1) Average service life: 100,000 h at TU = +25 °C.
  • 2) In relation to long side of housing.

• Mechanics/electronics

  Supply voltage	12 V DC ... 24 V DC 1)
  Ripple	≤ 5 Vpp 2)
  Current consumption	< 50 mA 3)
  Switching frequency	15 kHz 4)
  Response time	32 µs 5)
  Jitter	15 µs
  Switching output	NPN
  Switching output (voltage)	NPN: HIGH = approx. VS / LOW ≤ 2 V
  Switching mode	Light/dark switching
  Output current Imax.	50 mA 6)
  Retention time (ET)	28 ms, non-volatile memory
  Time delay	Switch-off delay, 520 ms (via IO-Link)
  Connection type	Male connector M8, 4-pin
  Protection class	III
  Circuit protection	UV connections, reverse polarity protected Output Q short-circuit protected Interference pulse suppression
  Enclosure rating	IP67
  Weight	20 g
  Housing material	Plastic, ABS
  Optics material	Plastic, PMMA
  Indication	LED indicator green: power on LED indicator, yellow: Status switching output Q

  • 1) Limit values: DC 12 V (–10 %) ... DC 24 V (+20 %). Operation in short-circuit protected network max. 8 A.
  • 2) May not exceed or fall below Uv tolerances.
  • 3) Without load.
  • 4) With light/dark ratio 1:1.
  • 5) Signal transit time with resistive load.
  • 6) Total current of all Outputs.

Technical drawings

 

Dimensional drawing KTM Prime

Adjustments KTM Prime

Connection type See table: Connection/Pin assignment

 

Setting the switching threshold (dynamic)

Setting the switching threshold (static)

Sensing distance