MBS 9075/ 9072 - Metallic Grey

MBS 9075 (Metallic Grey)
MBS 9072 (White)

Colour: MBS 9075/ 9072 Metallic Grey / White
Botton Aluminium Skin Thickness: 0.15mm
Panel Core: LDPE
Width: 1220mm
Length: 1220mm/ 2440mm/ 3050mm/ 3660mm/ 4270mm/ 4880mm/ 5490mm/ 6100mm/ 6710mm/ 7320mm
Panel Thickness: 4mm

*Measurement subject to tolerance
*Above stock code for reference only
Please feel free for inquiry for the any of the above stock code needed

 

Installation Method

MBOND® Aluminium Composite Panel (Mbond ACP) is produced with a protective PE film on one or both sides which should be kept on until the panel is fastened.

To install, 50mm of protective film should be peeled off from the edges of the sheet to allow clean sheet insertion into the glazing system. 

The residual film should be removed immediately after the glazing is completed.

Make sure the support structure is clean and dry. Do not directly screw the sheet, only use aluminium clapping for joining. Must leave a gal of at least 5mm in between sheets for thermal expansion and contraction. A minimum slope of 5º roof pitch is recommended to allow adequate rain water run-off.

MBond® Aluminium Composite Panel can be cold-form by : –
* a/b >= 2
* Ø < 90
* R >= 180t

Maintenance & Stoprage Guidelines

Storage

Sheets should be kept indoor, protected from sunlight and rain fall by an appropriate opaque waterproof roof cover.

Cleaning Method

Use only neutral detergent or mild soap for cleaning. Wash by using soft cloth op sponge. Rinse off with lukewarm water (below 60C).

Cutting Method

Use circular saw blade for cutting MBOND® Aluminium Composite Panel.