Penerangan

DREMEL 108 Engraving Cutter

To perform best results of Dremel 108 Engraving Cutter, Dremel recommend users:

• Insert the accessory bit all the way into the tool and then back it out slightly before tightening down. This provides plenty of shank for the collet or chuck to hold onto the bit.
• Secure objects to a stable surface while working.
• Use the sides of the cutter (rather than the tip) for effective cutting. The tip cuts poorly and can break under pressure.
• Use higher speeds for hard woods, slower speeds for metals and very slow speeds for plastics (to avoid melting at the point of contact).
• If chattering occurs, increase speed. 

• Shank diameter: 3.2 mm
• Working diameter: 0.8 mm
• Maximum RPM: 35,000 1/min

 *There are options for walk-in purchases.
*We always try to keep the item in stock all the time.
=========================================
 
Contact Information:
 
Balakong:
017-3691406,[email protected]
017-3691038,[email protected]
603-89623888   
603-89617328
 
Setapak:  
016-6616801(whatsapp)  
016-6613186(whatsapp), [email protected]
012-9380198, [email protected]
603-40219399  
        
Gombak:
603-40318686(whatsapp)
016-7166820, [email protected]
016-6616081, [email protected]
 
Titiwangsa:
012-9380198, [email protected]
603-40319292
 
Kajang:
016-6613186(whatsapp) Tel:017-3691038
 
Knight Auto Sdn Bhd (Since 1999)(476359-M)  
A Wholly-Owned Subsidiary of Lim Seong Hai Capital Berhad
http://www.knightauto.com.my
=========================================

Lebih maklumat tentang Knight Auto Sdn Bhd