LPV-18E: Top Choice in Selangor, Malaysia, Kuala Lumpur (KL), Shah Alam Winston Resources

Description

Features:
‧180-264VAC input only
‧Fully encapsulated with IP67 level (Note.5)
‧Protections: Short circuit / Overload / Over voltage / Over temperature
‧Cooling by free air convection
‧Class 2 unit ,no FG
‧Pass LPS
‧100% full load burn-in test
‧Suitable for LED lighting and moving sign applications
‧High reliability / Low cost
‧3 years warranty

Model		LPV-18E-12		LPV-18E-24		LPV-18E-36
Output	DC voltage	12V		24V		36V
	Rated current	1.5A		0.75A		0.5A
	Current range	0~1.5A		0~0.75A		0~0.5A
	Rated power	18W		18W		18W
	Ripple&noise (max.)	120mVp-p		150mVp-p		200mVp-p
	Voltage tolerance	±3.0%
	Line regulation	±1.0%
	Load regulation	±2.0%
	Setup,rise time	1500ms,30ms / 230VAC
	Hold up time	50ms/230VAC at full load
Input	Voltage range	180 ~ 264VAC , 254 ~ 370VDC
	Frequency range	47 ~ 63Hz
	Efficiency	77%	82%					83%
	AC current	0.3A/230VAC
	Inrush current	Cold start 50A(twidth=155μs measured at 50% Ipeak) at 230VAC
	Leakage current	<0.25mA/240VAC
Protection	Overload	Above 105% rated output power
		Protection type：hiccup mode，auto-recovery after fault condition is removed
	Over voltage	13.8~ 16.2V			27.6~ 32.4V		41.4~ 48.6V
		Protection type : Shut off o/p voltage, clamping by zener diode
	Over temperature	Hiccup mode, recovers automatically after temperature goes down
Environment	Working humidity	20%~90%RH non-condensing
	Storage temp,humidity	-40℃~+80℃,10%~95%RH non-condensing
	Temp. coefficient	±0.03%/℃ (0 ~ 50℃)
	Vibration	10~500HZ,2G 10min/1cycle,period for 60min, X.Y.Z each axes
Safety&EMC	Safety standard	TUV EN60950-1, TUV EN61347-1,EN61347-2-13,IP67 approved; design refer to UL1310 Class 2,CAN/CSA No. 223-M91
	Withstand voltage	I/P-O/P:3KVAC
	Isolation resistance	I/P-O/P:>100M Ohms / 500VDC / 25℃/ 70% RH
	EMC emission	Compliance to EN55022 Class B,EN61000-3-2 Class A, EN61000-3-3
	EMC immunity	Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level, criteria A
Others	MTBF	1100K hrs min. MIL-HDBK-217F (25℃)
	Dimension	1403022(LWH)
	Packing	0.175Kg; 70pcs/13.3Kgs/0.71CUFT

NOTE:
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 ℃ of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. Derating may be needed under low input voltage. Please check the static characteristics for more details.
5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
6. Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time.
7. Suitable for indoor use or outdoor use without direct sunlight exposure. Please avoid immerse in the water over 30 minute.
8. The unit might not be suitable for lighting applications in EU countries. Please check with your local authorities for the possible use of the unit.

More detail about Winston Resources