Description
A versatile hand kneadable, fast setting co-extruded epoxy repair system that can be used for repairing a multitude of things. It is especially suitable for application to damp, wet or underwater substrates. It comes in a handy roll form, with the white hardener encapsulated in the aqua green resin part. The product hardens in 20 - 30 minutes after mixing, to a white solid material.
Features
-
Will not sag, run or drip
-
Easy to use - no mess
-
Can be drilled, sawed, sanded, filed, tapped, machined or painted one hour after mixing
-
Good adhesive strength
-
Can be used to reshape, rebuild and repair a multitude of surfaces and applications
-
Good gap filling properties
-
Long-lasting, durable solution
-
Heat resistant to 120°C continuously or 140°C intermittently
-
Can be used under fresh or salt water
-
Longer set time (less than 20 min)
-
Higher tack for underwater repairs
Ideal for
-
Fibreglass
-
Wood/Timber
-
Ceramics
-
Meta
-
Concrete
-
Glass
-
Most plastics (pre-test required)
-
Masonry
Direction
-
Clean surface free of grease, dirt and dust. For best results roughen bond area prior to cleaning.
-
Cut off required amount. Replace disc on remaining portion. Wear gloves to avoid messing hands. To mix, knead with fingers to uniform colour. If mixing is difficult, warm to room temperature.
-
Apply to surface to be repaired (within 12 minutes of mixing) and work the material forcefully into the surface applying pressure until adhesion begins to take effect. Mould to shape if required. If material sticks to fingers, use the plastic wrapper to press the material in place.
-
For a smooth appearance, remove excess and hand rub with water or a damp cloth before hardening begins.
-
Trim away any excess before initial hardening. Remove any residues with acetone prior to initial hardening. Hardened excess may be sanded or trimmed away once fully cured.
-
After 60 minutes Knead-It Underwater may be drilled, sanded, machined, filed, sawed or painted.
-
Wash hands thoroughly with soap and water after use.
Safety tips
-
Where possible wear protective gloves when using Knead-It Underwater. Contact with skin may result in irritation. Epoxy resin is a known skin sensitiser. Repeated or prolonged skin contact may lead to allergic contact dermatitis.
-
If redness or swelling of skin occurs, wash thoroughly with soap and water. Seek medical attention if in any doubt.
-
Mixed and cured material is not hazardous. Cured material can only be removed by cutting and abrasion. If cured on skin, it will peel off in a few days without assistance. Soaking in warm water will assist removal.
More detail about Safety Solutions (M) Sdn Bhd
Malaysia
