HOW TO DIP
Dipping (14.5 and 22 oz. cans)
Surface must be clean and dry. For best results, avoid direct sunlight, high humidity or breezy conditions.
Stir gently and thoroughly before each use.
Attach wire or string to hang item.
Insert item 1” every 5 seconds; withdraw at same rate.
Recommended 2-3 coats for best results.
Allow 30 minutes minimum dry time before use.
Brushing (14.5 and 22 oz. cans)
Surface must be clean and dry. For best results, avoid direct sunlight, high humidity or breezy conditions.
Stir gently and thoroughly before each use.
Dilute as needed (10-20%) with naphta.
Apply heavy coats; avoid brushing back and forth.
Allow 30 minutes minimum between coats. Apply as many coats as desired.
Dipping/Brushing Tips:
If thinning is desired, product thickens, or for cleanup, use naptha, xylene (xylol), or toluene (toluol) solvents. Allow 4 hours per coat for complete dry. Keep container tightly closed when not in use. When applied properly Plasti Dip can be removed from most surfaces, if desired.
HOW TO SPRAY
Spraying (11 oz. aerosol)
Surface must be clean and dry. For best results, avoid direct sunlight, high humidity or breezy conditions.
Shake can vigorously for one full minute after mixing ball begins to rattle. Shake often while applying.
Hold can 6-10” from surface, moving can back and forth, slightly overlapping each stroke. Apply heavily enough to produce an even, wet appearance.
Allow 30 minutes minimum between coats. Apply as many coats as desired (3-4 average).
Allow 4 hours minimum dry time before use. Coverage: Approximately 5-10 sq. ft. per can.
Spraying Tips:
Always protect surrounding areas from overspray. Allow 4 hours per coat for complete dry. If runs or sags are experienced, move can further away from surface. To avoid clogged nozzle, turn can upside down and spray for 5 seconds. If clogged, remove nozzle and soak in naphtha or mineral spirits for 30 minutes. Do not stick pin or other objects into stem. Use naphtha, xylene (xylol), or toluene (toluol) for cleanup. To greatly increase non-skid properties, sprinkle a generous amount of grit onto wet surface of first coat. Apply at least two additional coats of Plasti Dip. For best results, use a pumice (crystalline silica) grit. Results may vary with other grit additives. When applied properly Plasti Dip can be removed from most surfaces, if desired.
GLOW
Create a glow-in-the-dark look by adding our Glow colors on top of Plasti Dip White spray.
Plasti Dip Glow is available in 11 oz. aerosol cans.
Malaysia
