About DOWELL DSG-2040H/2040AND
| ITEMS | UNIT | 3A2460H 2460AND |
||
| GENERAL CAPACITY | Table Size | mm | 500x1050 | |
| Max.grinding length | mm | 1050 | ||
| Max.grinding width | mm | 500 | ||
| Distance from table surface to spindle center | mm | 600/800(opt) | ||
| Standard mag.Ghuck size | mm | 500x1000 | ||
| LONGITUDINAL MOVEMENT | Manual travel | mm | - | |
| Hydraulic traverse | mm | 1100 | ||
| Hydraulic feed (table speed) approx. | m/mm | 3~25 | ||
| CROSS MOVEMENT | Manual travel | mm | 575 | |
| Auto cross feed | mm | 550 | ||
| Hand feed per revolution | mm | 5 | ||
| Hand feed per graduation | mm | 0.02 | ||
| Continuous cross feed (approx.)50/60HZ | mm/min | 1000 | ||
| Increment cross feed | mm/min | 1~20 | ||
| VERTICAL DOWNFEED | Rapid traverse (approx.) | mm/min | 800 | |
| Slow traverse (approx.) | m/min | - | ||
| Hand feed per revolution | mm | AND : 0.1mm/MPG | ||
| Hand feed per graduation | mm | AND : 0.001mm/MPG | ||
| Auto downfeed rate | mm | 0.001~0.06 | ||
| Jog | mm | 0.001 | ||
| Pre-set spark out times | 0~99(passes) | |||
| Manual pulse generator | x1, x5, x10 | |||
| GRINDING WHEEL | Wheel size (diax width xbore) | mm | Ø355x38x127mm | |
| Spindle speed (50/60HZ) | rpm | 1450/1750rpm | ||
| MOTORS | Spindle drive motor | hp | 7.5HP/10HP (OPT) | |
| Hydraulic motor | hp | 5HP | ||
| Cross feed motor | hp | 1/4HP (SIEMENS) | ||
| Elevating motor | w | - | ||
| Rapid hand elevatipn servo motor | kw | 1 | ||
| WEIGHT | Net weight/gross weight(approx.) | kg | 5900/6900 | |
| PACKING SIZE | Lengthxwidthxheight | mm | 3600x2230x2280 | |
| •Specification is subject to change without further notice. | ||||
Malaysia
