Main control card for modular AN-E OLT8000, supports, SNMP MIB, EMS system and control functions: Top Choice in Selangor, Malaysia, Kuala Lumpur (KL), Petaling Jaya (PJ) Catacomm Corporation Sdn Bhd

Description

AN-8000-M is a module that must be installed in AN-E-OLT8000 to get it work, and at least 1 SFP module for uplink must be installed. More modules can be added later as your network grows. AN-8000-M performs 2 main functions exchange and control. Exchange part provides 2 layers of exchange functions to PON module cards, and control port gives control function possibilities for all GEPON system. Core part of the board is 16 port GB chip – 8 ports are connected to uplink SFP’s, and another 8 – to downlink PON modules further connected to ONU’s.

Features

8 x 1.25 GB SFP slot uplinks to network (switches, routers, IP-PABX, or IPTV servers)
Uplink ports can accept any kind and distance and SFP’s, also UTP type SFP’s
If configured under electric UTP type port, it can work in adaptive 10/100/1000 Mbit/s modes
Supports VLAN division per ports
Supports 802.1Q, 802.1P protocols
Up to 4096 entries for VLAN’s
Capacity for supported MAC addreses is 16K
Supports broadcast restrain function in down links, this can protect PON network from influence of broadcast storms
Supports broadcast discharge which is permitted by bandwidth granuality configuration based on 64Kbit/s
Supports ports convergence function – up to 8 converged ports are supported, which means converged port BW can be up to 8 Gbit/s.
Offers 2 control interfaces, local and network
Support 3 types of management: CLI, TELNET and SNMP
Network control supports in-band and out-band
Memory capacity 16M – which can store big amounts of configuration
Real time fault alarms by indicators and in EMS

Specifications

Power consumption >15 W (please check whole chassis specifications here)

Uplink data ports specifications:

Number of ports: 8

Form: SFP type

Voltage: 3.3V

Speed: for Optical modules 1000M full duplex, for Electrical type (such as this) – 10/100/1000 adaptive

Console port:

Interface type: RJ-45, console cable RJ45/DB comes in set

Speed: 9600 Bit/s

Outband network management interface:

Standard: IEE802.3

Transmission speed: 10M Full duplex

Cable: RJ-45, use cross cable to connect to PC, or straght to connect to HUB

Distance 100 m

Ordering Information

AN-8000-M

Main control card for modular OLT – supports, SNMP MIB, EMS system and control functions (must be inlcuded in each chassis).

More detail about Catacomm Corporation Sdn Bhd