Pumping speed:
170÷15330 m3/h
Aerzen vacuum blowers are provided with O-ring sealings at the casing flanges. Further important advantages of the blower stage are the vacuum-tightness and air cooling. The lube oil supply is carried out by oil splash lubrication. The conveying room is protected by combined oil slinger-piston ring labyrinth sealings. The integrated canned motor ensures the sealing of the drive shaft, a shaft passage to atmosphere can be omitted.
Regarding the motors it can be chosen between a high-frequency design with a maximum speed of 7.400 rpm (125 Hz) or a system frequency design with a maximum speed of 2.970 rpm at 50 Hz resp. of 3.565 rpm at 60 Hz. Upon request these motors can be applied with corresponding frequency converters for lower speeds and smaller conveying quantities.
Thanks to the water cooling of the motor, Aerzen canned blowers are appropriate for the application under clean-room conditions. Air-cooled canned motors can be delivered upon request.
The canned material is made of special stainless steel and is therefore corrosion-resisting. Depending on type of process it can be selected between two high-frequency motor variants: For continuous operation the C-motors are designed for a maximum load of 50 mbar, at cyclic operation the Y-motors can be loaded with 150 mbar (< 5 minutes), realizing considerably shorter pump periods.
|
|
|
|
GM/GL CM-N |
GM/GL CM-Y |
GM/GL CM-C |
|
Type of use |
|
|
Network frequency |
For high frequency cyclic operation |
For high frequency continuous operation |
|
Pumping speed* |
m³/h |
|
from 170 to 9530 |
from 450 to 15330 |
from 2400 to 15330 |
|
Operation frequency* |
Hz |
|
50 and 60 |
min 40 max 125 |
min 40 max 120 |
* depending on the Roots pump
Malaysia
