Product Specification About ASG All Purpose Joint Compound/ Plaster Compound (Ready-Mixed/Non-Asbestos)
Capacity : 5Kg
- ASG MULTI PURPOSE READY-MIXED/ NON-ASBESTOS JOINT COMPOUND Special Vinyl formulation that require
minimal mixing to thinning provides a smooth seamless finish for Gypsum Board Wall, Ceiling Joints and brick wall.
- ASG MULTI PURPOSE JOINT COMPOUND used for taping, finishing Gypsum Board applications.
- It is an ideal material for embedding fasterners, corner surfaces where necessary.
- It can also be used to repair crack on brick wall surface. It complies with .
ASTM C 475.
Technical Reference:
● ASTM C 475 Standard Specification for Joint Compound Joint Tape for Finishing Gypsum Board
● ASTM C 840 Standard Specification for Application and Finishing of Gypsum Board
Preparation:
● Store ASG JOINT COMPOUND at room temperature for 24 hours prior to the application.
● Stir content lightly, do not add water.
● Use directly from the container when use for covering embedded fasterners, corner beads and trims.
● If necessary add 1/2 pints (250ml) of water, remix gently.
● Keep container covered when not in use.
Sanding:
Sanding is not allowed. If required, use very fine sandpaper of grit 150
Application:
1. Apply ASG JOINT COMPOUND only on dry surfaces.
2. Apply thoroughly and allow each coat to dry before apply the next.
3. Keep air to the minimum, joint compound surface temperature 26/30 °C within working area until joint are completely dry.
CAUTION
- Sanding dust (from out sanding) may cause eye, nose, throat or upper respiratory irritation, long term breathing of
large amounts of mica may cause lung disease.
- Use wet sanding technique to avoid creating dust, if dry sanded, wear a NIOSH approved dust mask.
- Do not take internally. the use of safety glasses is recommended.
Malaysia
