Teclock Durometer Hardness Tester GS-619/620/621 Series

Teclock Durometer Hardness Tester Durometer GS-619/GS-620/GS-621 series – corresponding to ISO and JIS standards of rubber hardness measurement. Presented by MSP Metrology (M) Sdn Bhd from Teclock Japan.
 

Features

For Hardness Test of Vulcanized or Thermoplastic Rubber

These Durometers are in compliance with JIS K 6253, JIS K 7215, ISO 7619 and DIN 53505 etc., and are designed faithfully by ” Rubber, vulcanized or thermoplastic Determination of hardness ” in JIS K 6253.

• Indication error is ±0.5 Dial reading, so it is improved reliability.
• In case using stand, select R type (Pressurized Face φ18mm) .
• Recommendation Stand is GS-610Ⅱ. As usage, can be selected GS-612 or GS-615 (P148).
• Calibration certificate can be issued as Standard.

Peak Pointer Type   

Some of Rubbers, Elastomer’ elastic body is not easily read the maximum value after firm contacting with a presser foot of durometer , due to the stress relaxation. The pointer indicates the descendent value but the peak pointer is holding the maximum measured value. The peak pointer type can easily read the maximum value efficiently.

In case the pointer cannot be read directly due to some obstacles altough the measuring can be done, the mesured value can be confirmed from peak pointer after measuring. The upper / lower limiters equipped will be effectively used in tolerance judgment.

Pressurized Face φ18mm Durometer mounted to Stand

Pressurized face diameter of type A and type D durometer mounted to a stand is defined 18mm by JIS standard and ISO standard. φ18mm type A(GS-719R) and type D (GS-720R) can be used as they are for measuring by pushing by hand.

Specifications

Dimension