Automatic Tape Cutter ATDC-2000

 Applicable tape categories: All with adhesive tape and no adhesive tape
 Digital display cutting length setting
 Manual / automatic two modes
 Can cut two rolls of tape at the same time
 The mounting tape is a rollerless design that has no restrictions on the inside and outside diameter of the tape
 Absolute safety operation design


Automatic Tape Cuter ATDC-2000 applicable tape width range from 6mm to 60mm The machine has a manual / automatic two modes, are free to choose.The installation tape is no roller design, so there is no restriction on the inner diameter and outer diameter of the tape, which is 100% satisfied with the offset paper of any diameter.This machine has the advantage of being safe, efficient and convenient.


Features:
 Applicable tape categories: All with adhesive tape and no adhesive tape
 Digital display cutting length setting
 Manual / automatic two modes
 Can cut two rolls of tape at the same time
 The mounting tape is a rollerless design that has no restrictions on the inside and outside diameter of the tape,which is 100% satisfied with the offset paper of any diameter.
 Length recovery function, when you set the error, you can restore a key to the initial data (20mm), and then re-set
 Increasing the length can be in place (mm) increments and tens (cm) increments, so that you can quickly set the length of adhesive pape
 There is an infrared sensor next to the scissors. Automatically, you can take a piece of automatic induction and then a very save time. A single machine can be used by many people at the same time.
 Absolute safety design. The first safety design is to design a safety barrier at the scissors. The second safety design is that the machine automatically stops working after the machine is blocked by adhesive tape. Even if the obstruction is cleared, the machine does not work immediately. You must press the start key again before continuing.