Description
PENTENS T-100
Water-Based PU Bituminous Waterproofing Membrane
PENTENS T-100 is a single component, a newly developed polymer of MMA, natural rubber, and polyurethane combined with asphalt and then modified and further emulsified to form an elastic waterproof membrane. PENTENS T-100 is an environmentally friendly and low VOC material.
ADVANTAGES
- Low VOC & Non-formaldehyde
- Environmentally friendly
- High elasticity
- Will bond to most surface
- Does not run or creep under heat
- Resists to a wide range of acids and alkalis
- Can be applied directly on damp or wet surfaces
- Odourless and produces no fumes
- Non-toxic
USES
To provide better water and vapour proof in complicating application surface compare to membrane-type and ensure better integrity between applied surfaces and waterproofing coating.
Areas of application include:
- Basement
- RC flat roof
- Floor slabs
- Patios
- Terraces
- Balconies
- Internal wet area
- RC gutter
- RC planter box
- Lift pit
- Retaining walls
- Swimming pool
- Fountain
APPLICATION
Dilute 1 portion of PENTENS T-007 permeable primer or 1 portion of PENTENS T-100 with 3 portions of clear water and then plaster directly to the surface to be waterproofed at the rate of 0.2kg/m2 in order to improve the bonding. Using brush, roller or spray, apply the first coat of PENTENS T-100 on the surface. Leave to cure for approximately 8 hours before applying the second coat.
SAFETY
Impervious gloves and barrier cream should be used when handling these products. Eye protection should be worn. In case of contact with eyes, rinse with plenty of water and seek medical advice if symptoms persist. If contact with skin occurs, it must be removed before curing takes place. Wash off with an industrial skin cleanser followed by plenty of soap and water. Do not use solvent. Ensure adequate ventilation when using these products.
More detail about PAINT MASTER SDN BHD
Malaysia
