UB400-12GM-E5-V1: 马来西亚的首选 Winston Resources

详情

Technical data

General Specifications
Sensing distance	30…400mm
Adjustment range	50…400mm
Unusable area	0…30mm
Standard target plate	100mm×100mm
Transducer frequency	About 310kHz
Response delay	About 50ms
Indicators/Operating means
LED blue	Power on
LED yellow	indication of the switching state Flashing:program function object detected
LED red	permanently red: Error Red,flashing:program function,object not detected
Electrical specifications
Operating voltage U B	10…30VDC,ripple10%ss
No-load supply current	≤30mA
Input
Input type	1 TEACH-IN input Operating distance A1:-U B …+1V,operating distanceA2:+6… + U B Input impedance:＞4.7KΩ TEACH-IN programmable pulse :≥1S
Output
Output type	1 switch output E5,PNP NO/NC,programmable
Rated operational current	100mA,short-circuit/overload protected
Default setting	Switching point A1:70mm Switching point A2: 800mm
Voltage drop	≤ 3V
Repeat accuracy	≤ 1%
Switching frequency f	≤ 8 HZ
Range hysteresis H	1% of the set operating distance
Temperature influence	± 1.5% of full-scale value
Ambient conditions
Ambient temperature	-25…70℃(248...343K)
Storage temperature	-40…85℃(233...358K)
Mechanical specifications
Protection grade	IP67
Connection	V1 connector(M12×1),4-pin
Material Housing	brass,nickel-plated
Transducer	epoxy resin/hollow glass sphere mixture; Polyurethane foam
Weight	25g

Dimension

Adjusting the switching points

The ultrasonic sensor features a switch output with two teachable switching points. These are set by applying the supply voltage - U B or + U B to the TEACH-IN input. The supply voltage must be applied to the TEACH-IN input for at least 1s.LEDs indicate whether the sensor has recognised the target during the TEACH-IN procedure. Switching point A1 is taught with - U B ,A2 with +U B. Five different output functions can be set.
1. Window mode, normally-open function.
2. Window mode, normally-closed function.
3. One switching point,normally-open function
4. One switching point,normally-closed function.
5. Detection of objet presence.
Switching point, Setting distance only after power on. The internal clock can assure can't be changed after 5 mins when power
on. If want to change the switching point, the user can only setting the request distance after power restart.

更多 Winston Resources 相关资料