Solvent Recovery Unit (GAS410): 马来西亚的首选 Renetech Sdn Bhd

详情

Highly safe N2 gas sealed circulation system, which can be operated with a spray dryer unit

Features of Solvent Recovery Unit (GAS410)

The Inert N2 Gas Sealed System is used to prevent external discharge when combined with a spray dryer (ADL311SA or GB-210A) when using an organic solvent.
Dehumidifier (Freezer) integrated in GAS410. No extra Freezer/ dehumidi-fier equipment needed
Compressor included, no need for a separate compressor to operatethe spray dryer ADL311SA when using organic solvent samples
Flammable or toxic solvents can be processed by combining a N2 gas sealed circulation system and a solvent recovery system (with freezer and capacitor)
Explosion safety with closed loop N2 inert gas system
Recovery of solvent to protect the environment and enable minimized pollution.
Drying of easily oxidized materials is possible
Supports low temperature drying of materials that easily deform with heat
No freezing risk due to organic solvent with aqueous solution mixtures which could cause damage to the closed loop GAS410 system
Spray drying and recovery of products and solvents are performed with meticulously devised safety measures

Specifications

Item Code	212774
Model	GAS410
Solvent recovery system	Capacitor + freezer
Circulating gas	N2 gas (sealed circulation when connected to ADL311SA or GB-210A)
Circulating volume flow	0.12 to 0.65m3/min
Compressor (for spraying)	Linear compressor integrated
Circulation blower	Roots blower
Solvent recovery container	2L flask
Freezer	Air-cooled condensation full-sealed type: 400W R404A
Solvent recovery mechanism	Capacitor cooling mechanism
Filter	Cartridge filter
Instruments	Cooling trap temperature display monitor Filter differential pressure meter (Monitor for clogging of filter) O2 density display monitor Blower wind amount adjusting volume
O2 sensor	Solid electrolyte (Zirconium) limit current type
Pump	For circulation to measure Oxygen
Safety device	O2 density meter, Flammable gas alarm, Electric leakage breaker, N2 gas forced introduction (when removing nozzles)
Required N2 amount	15 L/h at 0.1 MPa
Accessories	Set of connection parts, anti-seismic clamps, interface cable, sample gas for gas alarm inspection, 2L flask
External dimensions（W×D×H mm）	700×950×1500mm
Power Source	000V Single phase AC200〜240V　5A（15A）
Weight	130kg

Maintenance and warranty

Conditions: temperature and humidity: 23 deg.C+/-5 deg.C, 65%RH+/-20% (no load)

External dimensions do not include protrusions.