Spot Weld Chisel And Bar, KEN5051200K

Kennedy Crowbars, Wrecking bars and Pry bars

Manufactured from carbon steel. These traditional designs are used by tradesmen in all industrial environments. Suitable for a wide range of general duty applications, ideal for dismantling timber constructions, opening packing cases and removing nails (depending on the type of bar). Also used in assembly applications offering safe leverage and alignment capability.

The Kennedy ?RASCAL BAR?

The Right Angled Seam Chisel And L Bar has been specially designed by Kennedy Tools for the separation of hard to reach spot welds and bonded panels as well as coping with the many traditional uses for pry & wrecking bars.
Features & Benefits
?Easily separates hard-to-reach spot welded or bonded panels
?Sharpened on three edges, the sharp end allows for penetration between the panels and both side edges allow for side impact to drive the panels apart without damage
?90 degrees end for use in hard-to-reach pinchweld areas
?Made from a super tough alloy steel 
?Will save the technician up to 15 minutes per panel replacement
The Right Angled Rascal Bar with three sharpened edges is designed to allow two-directional hammer use on quarter panels, rockers and any other pinchweld. The sharp end allows for penetration between the panels and the two lower edges allows for side impact to drive the panels apart. The chisel tip can be used for starting seam separation.