SIGMASCOPE SMP350: 马来西亚的首选 LUX & BRILLIANCE TECHNOLOGIES SDN. BHD.

详情

Features

Non-destructive, precise measurement of the electrical conductivity of non-ferrous metals
Measures according to DIN EN 2004-1 and ASTM E1004
Used with probe FS40, the handheld device meets the Boeing specification BAC 5651
High-resolution touchscreen display with virtual keyboard and user-friendly graphical user interface
Various measurement frequencies for different penetration depths, from 15 kHz to 2 MHz, depending on the probe
Operating temperature: 0 – 40 °C
Measurement range: 0.3 – 63 MS/m or 0.5 – 108 % IACS
Accuracy at room temperature: ± 0.5 % of the measured reading
Takes into account the temperature coefficient of electrical conductivity valid for each individual material
Automatic curvature compensation for known curvature diameters (down to the smallest diameter of 6 mm)
Manual temperature input and monitoring of temperature change over time (ΔT/Δt)
Enough memory for thousands of measuring applications and several thousand readings
Certified reference standards (in MS/m, % IACS) – traceable to internationally recognized calibration standards

Applications

Conductivity testing on raw materials for sorting and quality assurance
Inspection of alloys in coinage (e.g. conductivity of Euro coins)
Assessment of the hardness and strength of heat-treated materials
Checking for heat damage, material fatigue and cracks
Estimation of the phosphorous content in copper alloys or copper-bearing materials
Tracking of precipitation processes, e.g. in Cu-Cr alloys
Verification of the homogeneity of alloys
Scrap sorting

The solution for electrical conductivity measurement

The SIGMASCOPE® SMP350 is a compact handheld device for measuring the electrical conductivity of non-ferrous metals. It quickly and accurately measures the electrical conductivity of aluminum or copper. From the measured conductivity, you can then draw further conclusions about the hardness and strength of heat-treated materials. This lets you monitor the material stability of components that are exposed to large temperature fluctuations. Even heat damage and material fatigue can be determined simply this way.

To measure the electrical conductivity, the device employs the phase sensitive eddy current method (according to DIN EN 2004-1 and ASTM E1004). This type of signal evaluation enables non-contact measurement, even under paint or plastic coatings up to 500 μm thick. It also minimizes the influence of surface roughness.