Vibration Separator GY-200

Directions 1

• Prior to operate the separator, ensure all the components are fastened, no broken on the sieves, no damage on the machine body, electrical cables are connected properly (do not use a knife switch), and three phase power supply is ready.
• Please check whether the machine model and specification are the same as your order. Power supply is the same as shown on the machine plaque. (Tolerance for voltage is + / - 10 %)

Preparation

• Place screen pots with required mesh onto the machine base sequentially.
• Feed raw material on the top screen pot, and then close the lid.
• Adjust the height of telescope poles accordingly and fasten the telescope knobs. Tighten the two black screen pot holding knobs to secure the lid.

Operation

• When power supply is on, the red power indicator comes on.
• Set the timer ( between 0 – 30 minutes ).
• Switch the start button, the green indicator comes on and machine starts working until the setting timing is up.

Directions 2

• Check the electrical components and all moving parts regularly during operation. Adjust if needed.
• This machine is guaranteed for one year under normal operating condition. Please contact our offices or distributors should any irregularity arise during the one-year warranty period. Do not under any circumstances attempt to make any repairs or replacements.

Specification