|
OPERATION INSTRUCTIONS : |
When move the operation rod , the plunger ( iron core ) will be moved simultaneously so as to make cylinder become under negativepressure . Then , due to closed air pressure of the plank , the grease will get into the cylinder from the suction port . Now , operate the operating rod to extrude out the grease through pipe in the cylinder by principle of the plunger pushing open the specific pressure of 100kg/cm2 , down pressure valve will strart to eturn the grease to the oil tank . The operationg rod is to use of a spring to link on the injeector as a round storage tank to prevent from oil leaking.
|
|
|
|
ADVANTAGES : |
|
1. |
Manual type pump . Use of single pipe , so no need of pipe return device . With simple piping for best effect . |
|
2. |
Has smooth stickness to the lubricating surface with proper oiling capacity , so no surplus oil will be leaked out to stain with the surface of bench . |
|
3. |
No need to worry about the dirts & impurities entered into the oiling port , so it is more clean than other ways of lubrication.
|
|
|
|
SPECIFICATION TABLE : |
|
Spec. |
Oil |
Outlet |
Capacity |
Output Pressure |
grease distributor |
max. |
|
SK-224-T03 |
Grease oil |
2 cc / stork |
300 cc |
100 kg / cm2 |
SD |
60 |
|
SK-224-T08 |
800 cc |
100 kg / cm2 |
SD |
60 |
|
|
|
|
Malaysia
