Deskripsyon
Measuring Stand for Durometer Hardness Tester GS series – Mechanical test stand for controlled test force by MSP Metrology (M) Sdn Bhd from Teclock Japan
Description
Automatic type Motor Driving Durometer Stand
- Measured hardness only by operating switch.
- Adopting stepping motor driving system
- Alignment unit which realizes high
- contact between indenter (contact point)
- of durometer and test piece is mounted.
- 1kg can be measured by type A and type E durometer as they are
- Calibration certificate can be issued
Manual Operation type Durometer Stand with Speed Controller
- Speed controller with high reliability Alignment unit which realizes high contact between indenter (contact point) of durometer and test piece is mounted.
- 65mm for analog and 40mm for digital are obtained for possible measuring range.
- Shaft with square thread is adopted that can prevent holder falling down and moving up and down.
- 1kg can be measured by type A and type E durometer as they are.
- Calibration certificate of mass (with durometer) can be issued
Manual Operation type Durometer Stand
- Hardness can be measured by durometer with load prescribed by JIS by mounting durometer and manual operation.
- Adopting cam has realized easy operation and cost performance.
- Alignment unit which realizes high contact between indenter (contact point) of durometer and test piece is mounted.
- 1kg can be measured by type A and type E durometer as they are.
- Calibration certificate can be issued
Tingnan ang karagdagang mga detalye tungkol sa MSP Metrology (M) Sdn Bhd
