ELOBAU LEVEL SENSORS Malaysia Thailand Singapore Indonesia Philippines Vietnam Europe USA

Level measurement

Precise and reliable level detection is essential in a wide range of applications in industry and vehicles. elobau's products for continuous level measurement, level detection, or removal & dosing with integrated level measurement are ideal for your individual requirements.

 

Continuous level measurement

During continuous level measurement, a signal corresponding to the current fill level is constantly output over the entire measurement range.

 

Level measurement on reed-contact basis

The float switches output a quasi-analogue output signal via a reed resistance chain. To ensure a high measurement resolution of the fluid level sensor, a quasi-analogue output signal is offered with a reed grid of 5-35 mm. A small grid can be used if necessary to generate a very exact signal. The number of reed switches can be adapted as required to suit the application.

 

 Float switch / level sensor for continuous level measurement

Float level sensor 

2..2.. / 2..3.. 

Electronic 

Measurement resolution 5-35 mm 

Current / voltage signals

 Fuel level sensor 298 for continuous level measurement from elobau

Fuel level sensor 

298… 

4-/5-hole flange / internal thread 

Optimised for fuels

Capacitive level measurement

Capacitive level measurement is based on the capacitor principle. The capacitance is measured as a function of the fill level. This means the measurement result is precisely determined.

 

 Analogue level measurement according to the capacitive measurement principle

Capacitive level sensor 

212KK.0.

for conductive media 

 Level sensor for continuous level measurement (especially for non-conductive media)

Capacitive level sensor 

212KN.0.

for non-conductive media

 To Ultrasonic level measurement

Ultrasonic level measurement

Level detection

Special limit-level float switches provide overfill protection or dry-running protection of pumps.

Float switches side mount and miniature float switches on either the upper or lower end of the container are used to check whether the fill level in the tank exceeds or falls below a critical point.

 

 

With additional switching points, between empty warning or overflow warning, the level switches can also be used for control purposes.

The switches can be fully customised for your application. Use our online configurator to check for your specific requirements.

 

 

 

Miniature float switches

 

Float switches side mount

 

Bulk material switches

Removal & dosing with integrated level measurement

elobau has fuel level sensors and suction pipes for measuring the fill level, with additional intake and extraction pipes. This has the advantage of only one opening being necessary in the container and no other additional instruments are needed for filling or removing.

The fuel level sensors can be used in vehicles and industrial applications for conveniently removing and monitoring the fluid from canisters or other containers. Dry running of pumps is then easily prevented and reliability is ensured.

 

 Suction pipe S… from elobau for pump control

Suction pipe

S…

with level monitoring

 Float level sensor for SCR systems 351ADBU from elobau

Float level sensor

351ADBU

for SCR systems 

Heating circuit

 Fuel level sensor 361 TEA… for fuel tanks

Fuel level sensor

361TEA…

with feed and return pipe 

 Fuel level sensor for fuel tanks with feed and return

Fuel level sensor

351TEG..0..

with feed and return pipe