(20pcs) DIP Carbon Film Resistor 5% 1/2W 0.56惟(0.56R)

BUY (20pcs) DIP Carbon Film Resistor 5% 1/2W 0.56惟(0.56R) https://www.utsource.net/itm/p/12605160.html

Instructions:

1. Handling:

   • Handle with care to avoid physical damage.
   • Do not apply excessive force when inserting into circuits.

2. Mounting:

   • Ensure the resistor is securely mounted on the PCB or breadboard.
   • Use pliers or a similar tool to bend the leads if necessary, but avoid bending too close to the body to prevent stress fractures.

3. Soldering:

   • Preheat the circuit board to reduce thermal shock.
   • Use a soldering iron with a temperature between 300掳C to 400掳C.
   • Apply solder to the joint for 2-3 seconds, ensuring a good connection without excess solder.
   • Allow the joint to cool naturally.

4. Testing:

   • After installation, use a multimeter to verify the resistance value and ensure it is within the specified tolerance.
   • Check for any short circuits or open circuits.

5. Storage:

   • Store in a dry, cool place away from direct sunlight.
   • Keep in an anti-static bag if possible to prevent static damage.

6. Disposal:

   • Dispose of resistors responsibly, following local regulations for electronic waste.