1/4W 5% 5.1M DIP CARBON FILM RESISTOR

BUY 1/4W 5% 5.1M DIP CARBON FILM RESISTOR https://www.utsource.net/itm/p/9495364.html

Instructions for Use:

1. Handling:

   • Handle with care to avoid damaging the resistor or its leads.
   • Avoid bending the leads excessively as this can cause mechanical stress.

2. Mounting:

   • Ensure that the leads are bent at a distance from the body to prevent stress on the resistor.
   • Solder the resistor to the circuit board within the recommended temperature range to avoid damage.
   • Allow sufficient space around the resistor for heat dissipation.

3. Soldering:

   • Pre-tin the leads before soldering to ensure a good connection.
   • Use a soldering iron with a temperature setting of 350掳C or less.
   • Apply solder for no more than 3 seconds to each joint to prevent overheating.

4. Storage:

   • Store in a dry, cool place away from direct sunlight and corrosive environments.
   • Keep the resistors in their original packaging until ready for use to protect them from moisture and static.

5. Testing:

   • Use a multimeter to verify the resistance value before installation.
   • Ensure that the measured value is within the specified tolerance (卤5%).

6. Safety:

   • Always disconnect power before testing or handling the resistor.
   • Follow all safety guidelines and regulations when working with electrical components.