2010 Chip Resistor 1% 2M惟 3/4W

BUY 2010 Chip Resistor 1% 2M惟 3/4W https://www.utsource.net/itm/p/12604019.html

Instructions:

1. Handling:

   • Handle with care to avoid physical damage.
   • Avoid exposure to excessive humidity and temperature.

2. Mounting:

   • Use standard surface mount technology (SMT) equipment.
   • Ensure the soldering iron tip is clean and properly tinned.
   • Apply solder paste to the pads before placing the resistor.
   • Place the resistor on the PCB and reflow solder according to the recommended temperature profile.

3. Soldering:

   • Preheat the PCB to 100-150掳C.
   • Apply heat to the joint for no more than 10 seconds.
   • Allow the joint to cool naturally without disturbance.

4. Inspection:

   • Visually inspect the solder joints for proper wetting and absence of bridges or voids.
   • Use a multimeter to verify the resistance value and ensure it falls within the specified tolerance.

5. Storage:

   • Store in a dry, cool place away from direct sunlight.
   • Use within the recommended shelf life to ensure optimal performance.