Description
BUY KSD301 K75 75掳C Normally Open Temperature Control Switch Thermostats (5pcs) https://www.utsource.net/itm/p/12604482.html
| Parameter |
Value |
| Product Name |
KSD301 K75 75掳C Normally Open Temperature Control Switch Thermostats |
| Model Number |
KSD301 K75 |
| Type |
Temperature Control Switch |
| Switch Type |
Normally Open (NO) |
| Operating Temperature |
75掳C |
| Contact Form |
SPST-NO (Single Pole Single Throw - Normally Open) |
| Rated Voltage |
250V AC |
| Rated Current |
10A |
| Differential |
5掳C 卤 5掳C |
| Hysteresis |
5掳C 卤 5掳C |
| Reset Type |
Manual Reset |
| Mounting Type |
Snap-in or Screw Mount |
| Dimensions |
19mm x 19mm x 16mm |
| Material |
Ceramic Body, Metal Cap |
| Insulation Resistance |
>100M惟 at 500V DC |
| Dielectric Strength |
2000V AC for 1 minute |
| Operating Humidity |
95% RH (non-condensing) |
| Storage Temperature |
-40掳C to 85掳C |
| Package Quantity |
5 pcs |
Instructions for Use:
Installation:
- Ensure the switch is installed in a location where it can accurately sense the temperature of the environment or device.
- For snap-in mounting, align the switch with the mounting hole and press firmly until it clicks into place.
- For screw mounting, use the provided screws to secure the switch to the mounting surface.
Wiring:
- Connect the common terminal (COM) to the power source.
- Connect the normally open terminal (NO) to the load or device being controlled.
- Ensure all connections are tight and secure to prevent loose connections that could cause overheating or failure.
Operation:
- The switch will remain open until the temperature reaches 75掳C.
- At 75掳C, the switch will close, allowing current to flow through the circuit.
- When the temperature drops by approximately 5掳C (due to hysteresis), the switch will open again, breaking the circuit.
Maintenance:
- Regularly inspect the switch for any signs of damage or wear.
- Clean the switch using a dry cloth; avoid using water or solvents.
- If the switch fails to operate correctly, replace it immediately.
Safety Precautions:
- Do not exceed the rated voltage and current.
- Ensure the switch is installed in a well-ventilated area to prevent overheating.
- Do not modify the switch; doing so may void the warranty and compromise safety.
- Always disconnect power before performing any maintenance or installation.
(For reference only)
More detail about Utsource Holding Company Limited
