ACS108-8SN-TR

BUY ACS108-8SN-TR https://www.utsource.net/itm/p/12597194.html

Instructions for Use

1. Power Supply:

   • Ensure the supply voltage is within the specified range of 4.5V to 5.5V.
   • Connect the VCC pin to the positive supply and GND pin to the ground.

2. Current Sensing:

   • Place the current-carrying conductor through the center hole of the sensor.
   • The current flowing through the conductor will generate a magnetic field, which is detected by the Hall effect sensor inside the device.

3. Output Signal:

   • The output voltage (VOUT) is proportional to the sensed current.
   • For a nominal supply voltage of 5V, the sensitivity is 100 mV/A.
   • The output is centered around half the supply voltage (2.5V for 5V supply).

4. Calibration:

   • If necessary, calibrate the output using a known current source to ensure accuracy.
   • Adjust any external circuitry to account for the offset and gain.

5. Handling and Storage:

   • Handle the device with care to avoid damage to the leads and package.
   • Store the device in a dry environment within the specified storage temperature range.

6. Safety Precautions:

   • Ensure proper isolation when handling high currents to prevent electrical shock.
   • Do not exceed the maximum operating voltage or current ratings to avoid damaging the device.

7. Mounting:

   • Mount the device on a PCB using standard soldering techniques.
   • Ensure proper thermal management if operating at high temperatures or currents.

8. Testing:

   • Test the device in a controlled environment to verify its performance before integrating it into the final application.