FR107

FR107

Category: Available (Qty:9999999)
For more information, visit our official website at utsource.us

Description

BUY FR107 https://www.utsource.net/itm/p/12535081.html

Parameter Description Value
Part Number Full Part Number FR107
Type Rectifier Diode -
Package DO-41 -
Maximum Repetitive Peak Reverse Voltage (VRRM) Maximum Reverse Voltage 1000 V
Maximum Average Forward Rectified Current (IF(AV)) Continuous Forward Current 1 A
Peak Forward Surge Current (IFSM) Non-Repetitive Surge Current 8 A (8.3 ms single half sine wave)
Forward Voltage (VF) Typical Forward Voltage at IF = 1 A 1.1 V
Reverse Recovery Time (trr) Reverse Recovery Time 350 ns
Operating Junction Temperature (TJ) Operating Temperature Range -65掳C to +150掳C
Storage Temperature (TSTG) Storage Temperature Range -65掳C to +150掳C

Instructions for Use:

  1. Mounting:

    • Ensure proper heat sinking if operating near maximum current to maintain junction temperature within specified limits.
    • Avoid mechanical stress on the leads during soldering and handling.
  2. Soldering:

    • Use a temperature-controlled soldering iron.
    • Soldering temperature should not exceed 260掳C.
    • Soldering time should be kept to a minimum, typically no more than 3 seconds per joint.
  3. Electrical Connections:

    • Connect the diode with the correct polarity. The cathode (marked band) should be connected to the positive side of the circuit.
    • Ensure that the voltage applied does not exceed the maximum reverse voltage (VRRM).
  4. Surge Handling:

    • The diode can handle peak forward surge currents up to 8 A for short durations (8.3 ms single half sine wave). Ensure that the surge conditions do not exceed these limits.
  5. Storage:

    • Store the diode in a dry, cool place away from direct sunlight and corrosive environments.
    • Handle with care to avoid damage to the leads and body.
  6. Testing:

    • Before installation, test the diode using a multimeter or diode tester to ensure it is functioning correctly.
    • Check for continuity between the anode and cathode, and ensure there is no short circuit.
  7. Safety:

    • Always follow standard safety practices when working with electrical components.
    • Use appropriate personal protective equipment (PPE) as necessary.
(For reference only)

More detail about Utsource Holding Company Limited
Utsource Holding Company Limited
Utsource Holding Company Limited Electronic Component Wholesaler, IC Chip Distributor, IGBT Module Supplier in California, USA | Utsource Holding Company Limited