FML-G16S，FML-G16: Top Choice in United States (USA) Utsource Holding Company Limited

Description

Parameter	FML-G16S	FML-G16
Type	Magnetic Reed Switch	Magnetic Reed Switch
Contact Form	SPST-NO (Single Pole Single Throw - Normally Open)	SPST-NO (Single Pole Single Throw - Normally Open)
Rated Voltage	240V AC / 30V DC	240V AC / 30V DC
Rated Current	5A (AC/DC)	5A (AC/DC)
Maximum Switching Power	120W (AC) / 150VA (AC) / 15W (DC)	120W (AC) / 150VA (AC) / 15W (DC)
Insulation Resistance	>100MΩ at 500V DC	>100MΩ at 500V DC
Dielectric Strength	2000V AC for 1 minute	2000V AC for 1 minute
Contact Resistance	<100mΩ	<100mΩ
Operating Temperature Range	-40°C to +85°C	-40°C to +85°C
Storage Temperature Range	-40°C to +85°C	-40°C to +85°C
Humidity Range	5% to 95% RH (non-condensing)	5% to 95% RH (non-condensing)
Magnetic Sensitivity	10 to 150AT (typical)	10 to 150AT (typical)
Mechanical Life	10 million operations	10 million operations
Electrical Life	100,000 operations (at rated load)	100,000 operations (at rated load)
Mounting Type	Surface Mount	Surface Mount
Dimensions (L x W x H)	16mm x 5.5mm x 5.5mm	16mm x 5.5mm x 5.5mm
Weight	1g	1g

Installation:
- Ensure that the switch is installed in a location where it will not be subjected to excessive mechanical stress.
- Mount the switch on a flat, stable surface to ensure reliable operation.
Wiring:
- Connect the switch to the circuit according to the contact form (SPST-NO).
- For AC applications, connect the switch in series with the load and power source.
- For DC applications, ensure the polarity is correct if the load is sensitive to polarity.
Magnetic Field Requirements:
- The switch operates when a magnetic field of sufficient strength is applied.
- The magnetic sensitivity range is 10 to 150 AT. Ensure the magnet used is within this range for reliable operation.
Environmental Considerations:
- Avoid exposing the switch to environments with high humidity or condensation.
- Ensure the operating temperature is within the specified range (-40°C to +85°C).
Testing:
- Test the switch before installation to ensure it is functioning correctly.
- Use a multimeter to check the continuity between the contacts when the magnet is applied and removed.
Maintenance:
- Regularly inspect the switch for any signs of damage or wear.
- Replace the switch if it shows signs of failure or if the electrical performance degrades.
Disposal:
- Dispose of the switch in accordance with local environmental regulations.

By following these instructions, you can ensure the FML-G16S and FML-G16 switches operate reliably and safely in your application.

(For reference only)