NJMOP1772E: Top Choice in United States (USA) Utsource Holding Company Limited

Description

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC		-0.3		6	V
Input Voltage Range	VIn	Relative to Ground	-0.3		VCC+0.3	V
Output Voltage Swing	VOut	RL = 10kΩ	0	VCC-2		V
Quiescent Current	IQ			4		mA
Slew Rate	SR			0.5		V/μs
Large Signal Voltage Gain	AV	VCC = ±15V, RL = 2kΩ		100		dB
Input Offset Voltage	VIO			5		mV
Input Bias Current	IIB			70		nA
Common Mode Rejection Ratio	CMRR	f = 1kHz		80		dB
Power Supply Rejection Ratio	PSRR	f = 1kHz		80		dB

Power Supply Connection:
- Connect the power supply voltage (VCC) within the specified range (-0.3V to +6V).
Input Signals:
- Ensure input signals do not exceed the input voltage range relative to ground (-0.3V to VCC + 0.3V).
Output Load:
- For optimal performance, connect a load resistor (RL) of at least 10kΩ to achieve the full output voltage swing.
Quiescent Current:
- The device typically consumes 4mA of quiescent current. Ensure your power supply can support this requirement.
Slew Rate Consideration:
- The typical slew rate is 0.5V/μs. Design your circuit considering this parameter to avoid distortion in high-frequency applications.
Gain Configuration:
- For large signal applications, configure the gain appropriately. With VCC = ±15V and RL = 2kΩ, the typical voltage gain is 100dB.
Offset Voltage Adjustment:
- Be aware of the input offset voltage which can be up to 5mV. Compensation techniques may be necessary for precision applications.
Bias Current Management:
- The input bias current is around 70nA. Use appropriate input resistors to minimize errors due to bias current.
Noise Reduction:
- Utilize the common mode rejection ratio (CMRR) and power supply rejection ratio (PSRR) to mitigate noise from the power supply and common-mode signals.
Handling Precautions:
- Handle the device with care to avoid damage from electrostatic discharge (ESD). Follow proper ESD handling procedures.

(For reference only)