HYC9088A: Top Choice in United States (USA) Utsource Holding Company Limited

Description

Parameter	Description	Value
Device Type	High-performance CMOS microcontroller	HYC9088A
Package Type	QFP (Quad Flat Package)	44-Pin
Operating Voltage	Supply voltage range	2.7V to 5.5V
Clock Frequency	Maximum operating frequency	24 MHz
Flash Memory	Program memory size	64KB
RAM	Data memory size	4KB
EEPROM	On-chip EEPROM	256 bytes
ADC Channels	Analog-to-Digital Converter channels	8
Timer/Counters	Number of timers/counters	3
Communication Interfaces	Supported communication interfaces	UART, SPI, I2C
Operating Temperature	Temperature range for operation	-40°C to +85°C
I/O Pins	Number of programmable I/O pins	32
Power Consumption	Typical power consumption at 3.3V and 1MHz	0.7mA
Wake-up Time	From Power-down mode to active mode	4 μs

Power Supply:
- Ensure the supply voltage is within the specified range of 2.7V to 5.5V.
- Connect a decoupling capacitor close to the VCC pin to stabilize the power supply.
Clock Configuration:
- The device supports both internal and external clock sources. Configure the oscillator settings in the initialization code or through hardware connections as required.
Memory Programming:
- Use an appropriate programmer compatible with the HYC9088A to load the program into the flash memory.
- Verify the program after loading to ensure correct programming.
Peripheral Setup:
- Initialize ADC, timers, and communication interfaces in your application code before using them.
- Configure I/O pins as input or output according to the application needs.
Low Power Modes:
- Utilize low-power modes such as idle and power-down to conserve energy. Ensure proper wake-up conditions are set when using these modes.
Development Tools:
- For development, use IDEs that support HYC9088A, along with compilers and debuggers tailored for this microcontroller family.
Handling Static Electricity:
- Handle the device with care to avoid damage from static electricity. Use anti-static wrist straps and mats during handling.
Refer to Datasheet:
- Always refer to the detailed datasheet for comprehensive information on specific parameters and advanced features not covered here.

(For reference only)