HCPL-3120-500E SOP8
HCPL-3120-500E SOP8

 

HCPL-3120-500E SOP8

Utsource Holding Company Limited flag
Category: Available (Qty:9999999)
For more information, visit our official website at utsource.us
Visit Official Site Contact Us
Description

BUY HCPL-3120-500E SOP8 https://www.utsource.net/itm/p/12608945.html

Parameter Symbol Conditions Min Typ Max Unit
Input Forward Voltage VF IF = 20 mA 1.2 1.6 V
Input Peak Reverse Voltage VPRR 5 V
Input Capacitance Ci VR = 0 V, f = 1 MHz 40 pF
Output Collector-Emitter Saturation Voltage VCE(sat) IO = 10 mA, IC = 100 mA 0.3 0.5 V
Output Collector-Emitter Breakdown Voltage BVCEO IO = 0 mA 70 V
Output Leakage Current IOL VCE = 30 V 100 nA
Propagation Delay Time tPLH, tPHL VI = 5 V to 0 V, VO = 15 V to 5 V, IF = 20 mA, IO = 10 mA 2 4 μs
Power Dissipation PD Ta = 25°C 180 mW
Operating Temperature Range TA Storage Temperature -40 85 °C

Instructions for HCPL-3120-500E SOP8

  1. Handling and Storage:

    • Store the device in a dry environment with controlled humidity.
    • Handle with care to avoid damage to the leads and body.

  2. Mounting and Soldering:

    • Ensure proper alignment of the device during mounting.
    • Use recommended soldering temperatures and profiles to prevent thermal shock.

  3. Electrical Connections:

    • Connect the input side (pins 1-4) to the control circuit ensuring correct polarity.
    • Connect the output side (pins 5-8) to the load circuit ensuring correct polarity.
    • Apply appropriate decoupling capacitors near the power supply pins if necessary.

  4. Power Supply:

    • Ensure that the power supply voltage is within the specified operating range.
    • Verify that the power dissipation limits are not exceeded under all operating conditions.

  5. Signal Integrity:

    • Keep signal paths as short as possible to minimize noise and interference.
    • Ensure that the input signal meets the required threshold levels for reliable operation.

  6. Testing:

    • Test the device functionality after installation using a known good signal source.
    • Monitor temperature and current levels during testing to ensure they remain within safe operating limits.

  7. Safety Precautions:

    • Avoid exceeding the maximum ratings specified in the parameter table.
    • Ensure adequate ventilation and cooling if operating at higher temperatures or power levels.
(For reference only)

More detail about Utsource Holding Company Limited
Utsource Holding Company Limited
Utsource Holding Company Limited Electronic Component Wholesaler, IC Chip Distributor, IGBT Module Supplier in California, USA | Utsource Holding Company Limited
Contact Us flag