OP196G: Top Choice in United States (USA) Utsource Holding Company Limited

Description

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	V_S		-0.3		36	V
Input Voltage Range	V_IN	Relative to either input	-0.3		V_S+0.3	V
Output Voltage Swing	V_OUT	Load = 10 kΩ	0		V_S-1.5	V
Input Offset Voltage	V_IO			75		μV
Input Bias Current	I_B			2		pA
Input Offset Current	I_O			0.6		pA
Large Signal Voltage Gain	A_VL	V_S = ±15V, RF = 10 kΩ		200		dB
Slew Rate	SR	V_S = ±15V		0.4		V/μs
Unity-Gain Bandwidth	f_T	V_S = ±15V		8		MHz
Power Supply Rejection	PSRR	10 Hz ≤ f ≤ 1 kHz		120		dB
Common Mode Rejection	CMRR	V_S = ±15V		120		dB
Quiescent Current	I_Q	V_S = ±15V		1.7		mA

Power Supply Connections:
- Connect the positive supply voltage (V+) and negative supply voltage (V-) to the appropriate pins of the OP196G.
- Ensure that the supply voltage does not exceed the maximum rating of 36V.
Input Connections:
- Apply the input signal across the non-inverting (+) and inverting (-) input terminals.
- Keep the input voltage within the specified range relative to the supply voltages to avoid damage.
Output Connections:
- Connect the load to the output pin. The output voltage swing is dependent on the supply voltage and can go from 0V to V_S-1.5V under a 10kΩ load.
Biasing and Feedback:
- For stable operation, use appropriate biasing and feedback networks. A typical configuration might include resistors to set the gain and stabilize the amplifier.
Decoupling Capacitors:
- Place decoupling capacitors close to the power supply pins to reduce noise and improve stability. Typically, 0.1μF ceramic capacitors are recommended.
Operating Temperature:
- Ensure the operating temperature remains within the specified limits for reliable performance.
Handling Precautions:
- The OP196G is sensitive to electrostatic discharge (ESD). Handle with care and use proper ESD precautions during assembly and testing.
Testing:
- Before finalizing the circuit design, test the amplifier under various conditions including different supply voltages, temperatures, and input signals to ensure it meets the required specifications.

(For reference only)