ATTINY13A-PU: Top Choice in United States (USA) Utsource Holding Company Limited

Description

Parameter	Specifications
Package Type	PDIP (Plastic Dual Inline Package)
Pin Count	8
Operating Voltage	1.8V to 5.5V
Operating Temperature	-40°C to +85°C
Flash Memory Size	1KB
SRAM Size	64 Bytes
EEPROM Size	None
Clock Speed	Up to 9.6 MHz (with CLKOUT)
Program Memory Type	Flash
Data Retention Time	20 years @ 85°C
Endurance Cycles	100,000 write/erase cycles
I/O Pins	6
Analog Comparator	Yes
Brown-out Detection	Yes (BOD)
Power Consumption	6 μA @ 3V, 1 MHz
Sleep Mode Current	0.1 μA

Power Supply Connection:
- Connect VCC to pin 8 and GND to pin 4.
- Ensure the supply voltage is within the operating range of 1.8V to 5.5V.
Clock Configuration:
- The device can operate with an internal oscillator up to 9.6 MHz or external clock sources.
- For precise timing applications, connect an external crystal or ceramic resonator to XTAL1 and XTAL2 pins.
Programming:
- Use ISP (In-System Programming) via SPI interface on pins PB5 (MOSI), PB3 (MISO), and PB4 (SCK).
- Set fuse bits according to your application needs using a programmer like AVRISP mkII.
Reset Pin:
- Pin 1 serves as RESET. It can also be used as I/O if programmed appropriately.
- Pull it high to enable normal operation; pulling low triggers reset.
Brown-out Detection (BOD):
- Enable BOD in software to prevent erratic behavior at low voltages.
- Choose appropriate BOD level based on system requirements.
Analog Comparator:
- Utilize the analog comparator for comparing two voltages applied to its positive and negative inputs.
- Configure through software to control outputs based on comparison results.
Power Management:
- Implement sleep modes to reduce power consumption when processing is not required.
- Wake-up sources include pin change interrupts, watchdog timer, and brown-out detection.
Handling and Storage:
- Store in anti-static packaging to avoid damage.
- Handle with care to prevent static discharge and physical damage.

(For reference only)