HM6287LP55: Top Choice in United States (USA) Utsource Holding Company Limited

Description

Parameter	Description	Value
Operating Voltage (Vcc)	Supply voltage range	2.5V to 5.5V
Operating Current	Typical operating current	0.4mA
Storage Temperature	Temperature range for storage	-40°C to +85°C
Operating Temperature	Temperature range for operation	-40°C to +85°C
Package Type	Type of package	SOP-8
Output Type	Type of output configuration	Open drain
Maximum Load Current	Maximum current the device can handle	100mA
Communication Interface	Supported communication protocols	I2C
Addressing Mode	Number of addresses available	Up to 8 devices

Power Supply Connection: Connect Vcc to a power supply within the specified operating voltage range and GND to ground.
Communication Setup: Ensure that the I2C bus lines (SDA and SCL) are connected to pull-up resistors. The typical value for these resistors is 4.7kΩ, but it can vary depending on the bus length and speed.
Address Configuration: Configure the address pins as per your system requirements if multiple HM6287LP55 devices are used on the same I2C bus.
Initialization: Initialize the device using appropriate I2C commands as specified in the datasheet.
Reading/Writing Data: Use standard I2C read/write commands to communicate with the device. Refer to the datasheet for specific command codes.
Power Management: When not in use, place the device in a low-power mode or disconnect the power supply to conserve energy.
Handling Precautions: Handle the device with care to avoid damage from electrostatic discharge (ESD). Follow proper ESD precautions during installation and handling.

(For reference only)