W25X10CLUXIG TR

BUY W25X10CLUXIG TR https://www.utsource.net/itm/p/12611272.html

Instructions for Use

1. Power Supply Connection

   • Connect the Vcc pin to a power supply within the specified voltage range (2.7 V to 3.6 V).
   • Ensure the GND pin is connected to ground.

2. SPI Configuration

   • Connect the serial clock (SCK), master out slave in (MOSI), master in slave out (MISO), and chip select (CS#) pins to your microcontroller or SPI master device.
   • For dual/quad I/O operations, connect the additional data lines as required by your application.

3. Initialization

   • Before performing any read/write operations, ensure the device is properly initialized by bringing the CS# low and sending the appropriate command sequence.

4. Write Operations

   • Perform write enable (WREN) before any write commands.
   • Execute write commands such as Page Program or Sector Erase as needed.
   • Verify the write operation is complete by polling the status register (RDSR).

5. Read Operations

   • Issue read commands like Fast Read or Dual/Quad Output Fast Read.
   • Ensure the CS# remains low during the entire read cycle.

6. Protection Features

   • Utilize the software write protect (WRR) command to lock specific sectors or the entire memory.
   • Enable the block protection feature to safeguard against accidental writes.

7. Handling and Storage

   • Store in a dry environment to prevent moisture damage.
   • Handle with care to avoid static damage; use ESD-safe practices.

For detailed command sequences and timing diagrams, refer to the datasheet provided by the manufacturer.