FT234XD

FT234XD

Category: Available (Qty:9999999)
For more information, visit our official website at utsource.us

Description

BUY FT234XD https://www.utsource.net/itm/p/12611992.html

Parameter Description FT234XD Specifications
Operating Voltage Supply voltage range for the device operation 1.8V to 3.6V (VCCIO), 3.0V to 5.25V (VCC)
Data Interface Type of data interface supported by the device USB 2.0 High-Speed
UART Interfaces Number of UART interfaces 1
Flow Control Hardware flow control support Yes, via CTS/RTS
Bit Rate Maximum bit rate supported Up to 3 Mbps
FIFO Buffer Size of the FIFO buffer 256 bytes
Power Consumption Typical power consumption 20mA at 3.3V, 10mA at 1.8V
Operating Temperature Temperature range for reliable operation -40掳C to +85掳C
Package Type Physical package type QFN-28 (7x7mm)
Compliance Regulatory and industry standards compliance RoHS compliant, USB IF certified

Instructions for Use

  1. Power Supply Connection:

    • Connect VCC to a supply voltage between 3.0V and 5.25V.
    • Connect VCCIO to a supply voltage between 1.8V and 3.6V depending on the I/O logic level required.
  2. USB Connection:

    • Connect the USB D+ and D- lines to the corresponding pins on the FT234XD.
    • Ensure that the USB connector is properly shielded to minimize interference.
  3. UART Configuration:

    • Configure the UART settings using the appropriate configuration registers or software provided by FTDI.
    • Set up the baud rate, parity, stop bits, and flow control as needed for your application.
  4. Flow Control Setup:

    • Enable hardware flow control by connecting the CTS and RTS pins if required by your application.
    • Adjust the thresholds for flow control in the configuration software.
  5. FIFO Operation:

    • Utilize the FIFO buffer to manage data flow efficiently.
    • Monitor FIFO status flags to prevent overflow or underflow conditions.
  6. Driver Installation:

    • Install the latest drivers from the FTDI website to ensure compatibility and optimal performance.
    • Use the provided examples and documentation for driver integration.
  7. Testing and Validation:

    • Test the setup with known data patterns to verify correct operation.
    • Validate the setup against the desired bit rate and communication parameters.
  8. Environmental Considerations:

    • Ensure the operating temperature does not exceed the specified limits.
    • Protect the device from excessive humidity and static electricity.

For detailed information, refer to the official datasheet and application notes provided by FTDI.

(For reference only)

More detail about Utsource Holding Company Limited
Utsource Holding Company Limited
Utsource Holding Company Limited Electronic Component Wholesaler, IC Chip Distributor, IGBT Module Supplier in California, USA | Utsource Holding Company Limited