P80C86A-2: Top Choice in United States (USA) Utsource Holding Company Limited

Description

Parameter	Description	Value
Device Type	Microcontroller	P80C86A-2
Operating Voltage	Supply voltage range for operation	5V
Clock Frequency	Maximum frequency of the internal oscillator	12 MHz
Program Memory	Type and size of program memory	4KB EPROM
Data Memory	Type and size of data memory	256 bytes RAM
I/O Ports	Number of programmable I/O lines	32
Timer/Counters	Number and type of timers/counters	2 x 16-bit
Interrupt Sources	Number of interrupt sources	7
Package Type	Physical package type	40-pin PDIP
Operating Temperature	Range of temperatures for operation	-40°C to +85°C
Power Consumption	Typical power consumption at max clock frequency	450 mW

Power Supply:
- Connect the Vcc pin to a stable 5V DC supply.
- Ensure that the GND pin is properly grounded.
Clock Configuration:
- For external crystal or ceramic resonator, connect it between the XTAL1 and XTAL2 pins.
- If using an internal oscillator, ensure it is enabled in the configuration settings.
Program Loading:
- Load your program into the EPROM using a suitable programmer compatible with the P80C86A-2.
- Verify the program before final installation.
I/O Port Initialization:
- Configure the I/O ports as inputs or outputs according to your application needs using the appropriate control registers.
Timer Setup:
- Initialize the timers/counters by setting up the mode and prescaler values as required by your application.
Interrupt Handling:
- Enable interrupts globally and configure individual interrupt sources as needed.
- Write interrupt service routines (ISRs) for each used interrupt source.
Operating Environment:
- Ensure the operating environment stays within the specified temperature range to avoid malfunction.
- Place the device in a well-ventilated area to prevent overheating.
Testing:
- After setup, thoroughly test the microcontroller to ensure all functionalities are working correctly.
- Debug any issues that arise during testing.
Maintenance:
- Regularly inspect connections and components for signs of wear or damage.
- Keep the firmware updated if applicable.

(For reference only)