ADS1230: Top Choice in United States (USA) Utsource Holding Company Limited

Description

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VDD	Operating range	2.7		5.5	V
Supply Current	IDD	Normal operation		160		μA
Input Voltage Range	VIN	Relative to AGND	-0.3		VDD+0.3	V
Common Mode Input Voltage	VCM		AGND		AVDD	V
Differential Input Voltage	VDIFF		-0.3		AVDD-AGND-0.3	V
Output Data Rate	ODR	Configurable	20		4800	SPS
Resolution				24		bits
Gain		Configurable	1		128
Power-down Current	IPD	Power-down mode		1		μA

Power Supply Configuration:
- Connect the VDD pin to a power supply within the range of 2.7V to 5.5V.
- Ensure that the AGND and AVDD are properly connected to ground and power supply respectively.
Input Signal Connection:
- Connect the input signal to the AINP and AINM pins ensuring the voltage stays within the specified input voltage range.
- The common mode voltage should be between AGND and AVDD.
Configuration via SPI Interface:
- Use the SPI interface to configure the device settings such as output data rate, gain, and operating modes.
- Refer to the datasheet for specific register configurations.
Data Acquisition:
- After configuring, initiate a conversion by setting the appropriate command via the SPI interface.
- Read the output data from the device at the configured output data rate.
Power Management:
- To reduce power consumption, put the device into power-down mode when not in use.
- In power-down mode, the current consumption is minimized.
Reading Output Data:
- The output data can be read serially through the SPI interface.
- Ensure the timing and protocol adherence as specified in the datasheet.

For detailed information on specific commands and register settings, refer to the ADS1230 datasheet provided by Texas Instruments.

(For reference only)