Cedar Torque Tester (DIS-IP Series)

DIS-IP series has been discontinued. Please find the replacement model as link below:

Cedar Torque Tester WDISR-IP Series: https://mspmetrology.com/product/cedar-torque-tester-wdisr-ip-series/
Cedar Torque Tester WDISR-IPS Series: https://mspmetrology.com/product/cedar-torque-tester-wdisr-ips-series/
Cedar Torque Tester WDISR-RL Series (Separate Type): https://mspmetrology.com/product/cedar-torque-tester-wdisr-rl-series-separate-type/
 

Digital Torque Tester DIS-IP series with remote sensor designed for verification and calibration of manual torque tools up to 500 Nm by MSP Metrology (M) Sdn Bhd from Cedar Japan

Features
DIS-IP series (-IP05/5/50/200/500)
Suitable for managing various manual torque wrench & torque drivers
Standard model for static torque measurement
Bigger characters size and enhance user convenience.
Enable to be installed in a small space due to a separate type.
Enable to save 5 channels of pass/fail judgement criterion, and enable to change settings easily by switch channels even if the tightening term changes.

- Show “Measurement mode” “Measurement unit” Indication of “maximum, minimum, average”
- Switchable measurement unit
- Enable to save 5 sets of settings such as upper limit and lower limit
- 800 items of memory data
- Real-time output About every 1/180 seconds
- Data acquisition software can be downloaded for free
- The lineup of the DIS-IP series is DIS-IP05, DIS-IP5, DIS-IP50, DIS-IP200, DIS-IP500

Yes-No Decision Conditions etc. Can Save Five Channels

- A channel is only changed even if bolting conditions change.
- It is not necessary to reset up a maximum value and a minimum value one by one like former.